a little stuck...

[plague]

well i got up to 1.4 (140x10), but when i try 10.5x133 windows wont load. tried 1.8V, though its on a A7A266, so i dont know if thats really 1.8V or 1.89. I still am relatively new to all this so if anyone has any ideas let me know. also, how much voltage is too much for a t-bird? heh, right now, since the multiplier is a pain to change on this board, im running 10.5x100, 1050.

[Da Whip]

I have checked out some reviews and articles on Crucial PC-2100 and you should be able to easily get 150mhz out of it. My KK266 R handles 1.9 v w/ no prob. Back off the multiplier to 10 and try 145mhz and up.

[dozier768]

what psu do you have also i wouldnt be afraid to go to 2 volts some people go as high as 2.5 but make sure your temps are b-low 50 or so

[plague]

couldnt even tell ya my PSU. its 300 watts, and i only have 1 hdd and 1 cdrw. right now im at 1439 mhz, vcore is set to 1.85, although asus probe says 1.936~1.95. thats the highest setting i have in bios. its 143x10, and if i go to 144 i get a registry error when windows starts. probe says my cpu is 57C, but using radiate i calculated 48C. dunno what else to do, all i wanted was 1.5 ghz...doesnt look to good right now.

[plague]

hmmm, still havent gotten past 1439. think thats all i can get?? i really wanted 1.5, i do have a glaciator so im not worried about heat, i just dont know what else could be holding me back.