- Joined
- Jan 9, 2003
- Location
- California
I just swapped up from a 2100 Tbred B on a KT400 (gigabyte GA-7VAXP) to a Asus A7N8X DLX 2.0 and a Barton 2500... I am currently running at 200x11 at stock voltage and I'm testing on PRIME as I type.
NOW, my diode temp at 100% load is hovering around 47C with a case temp around 24C. I'm using SLK900a with Tt SmartFan 2 on temp control, currently whirring at around 4000 RPM.
What kind of diode temps is everybody running at on their 2.0 boards? Is 47C high? My old chip (Tbred) on the KT400 chip used to run a lot cooler, but then again the gigabyte chips were notorious for having flaky temp sensors. I just want to get a sense of where I stand against other boards running similar setups.
Also, here's a strange little tidbit: I burned in for about 48 hours running at 100x11 at 1.85 volts and my temps were about 2~3 degrees COOLER. I'm currently running all my oc adjustments at stock voltage (1.65) and I'm noticing that everytime I raise the FSB, the load temp seems to go up. Anyone else notice this?
NOW, my diode temp at 100% load is hovering around 47C with a case temp around 24C. I'm using SLK900a with Tt SmartFan 2 on temp control, currently whirring at around 4000 RPM.
What kind of diode temps is everybody running at on their 2.0 boards? Is 47C high? My old chip (Tbred) on the KT400 chip used to run a lot cooler, but then again the gigabyte chips were notorious for having flaky temp sensors. I just want to get a sense of where I stand against other boards running similar setups.
Also, here's a strange little tidbit: I burned in for about 48 hours running at 100x11 at 1.85 volts and my temps were about 2~3 degrees COOLER. I'm currently running all my oc adjustments at stock voltage (1.65) and I'm noticing that everytime I raise the FSB, the load temp seems to go up. Anyone else notice this?