Ok, here's my new setup
Notice the lame tubing job going into the cpu block.
It's the Innovatek X-flow. It came with 1/4ID 3/8OD compression fittings (WAY too small tubing), and i bought 3/8ID 1/2OD compression fittings off one of the websites (i forget which one).
The problem is I want to use 1/2ID 3/4OD tygon. I've tried using nylon and polypro barbs, and I just bought chrome 1/2" barbs to use. NOPE, they don't fit for some reason. I don't know what the problem is, they're all supposed to be 1/4 NPT.
Sooo, if anyone knows something that'll work or has any suggestions I'm all ears.
Also, would this set-up be ok w/ the tubing the way it is? I'm thinking the conversion hurts the flow rates significantly.
Notice the lame tubing job going into the cpu block.
It's the Innovatek X-flow. It came with 1/4ID 3/8OD compression fittings (WAY too small tubing), and i bought 3/8ID 1/2OD compression fittings off one of the websites (i forget which one).
The problem is I want to use 1/2ID 3/4OD tygon. I've tried using nylon and polypro barbs, and I just bought chrome 1/2" barbs to use. NOPE, they don't fit for some reason. I don't know what the problem is, they're all supposed to be 1/4 NPT.
Sooo, if anyone knows something that'll work or has any suggestions I'm all ears.
Also, would this set-up be ok w/ the tubing the way it is? I'm thinking the conversion hurts the flow rates significantly.