3.3V or 3.4V VIO Voltage setting?? HELP!

[OC-Master]

Two Quick Questions,

Should I use 3.3V or 3.4V for the vio setting? I know lots about computers and boards and stuff but the defualt setting for the Abit KT7A-RAID is 3.4V VIO and I thought it was supposed to be 3.3V since SD-Ram is rated 3.3V.

HELP!

-Also, does it make less physical amount of heat when lowering the VIO voltage, I never really checked.

[Bender]

3.3 is standard but many manufacturers go higher for better stability. I don't think it will really cause more heat so you should be fine.

[-=UR=- Ranger]

IMHO every setting up too 3.6 is fine. Which setting u should use depends on your overclock, your Brand of Ram and your Mobo. I would try the lowest possible setting. If it´s stable, fine if not up it in small steps until your System gets stable again. But there´s some Ram which can´t stand high Vio, so be careful. My Apacer Ram doesn´t like anything above 3,5 for example. But 3,4 is perfectly stable...
Just have a try, you won´t kill anything, if you be careful.
The extra amount of heat, caused by higher Vio seems to be minimal