Check this overclock

[Tacoman667]

I now have my new 1.33gig AYHJA "9" at 1.61gigs STABLE. I had to throw the vcore up to 1.98 but it's now stable at 11x146. Before I couldn't get my FSB above 144 so I took off my hsf on the chipset and cleaned it. I proceeded to lap it and found out that the damn thing was not flat by ANY means. This was why I couldn't get this badboy up there. Now I am stable and loving it. My MBM temps with the onboard CPU thermistor says 38 idle and 42 load but I don't trust it anymore. I am thinking of getting a compunurse or a temp probe of some kind soon, but I am stable as hell. God I love this stuff.

[Bender]

Very nice overclock. I cant wait to get my DD setup, it should be here by Tuesday.

[Colin]

Nice overclock. My week 23 AYHJA (9) would only run at 11 * 144 with watercooling. I added a HS to the clock gen and got it up to 11 * 145 but that was with 2.04 volts.

[jeff_harrison_344]

Hey nice O/C!

And you too Colin!

Man I cant wait till I get my new 1Gig AXIA and MSI K7T Turbo with my CAK38

[Colin]

I should note that the same chip is running at 1718 MHz @ 2.1 volts with dual 120 watt pelts.

[Tacoman667]

What PSU you have for those pelts? I need a PSU for my 156watter.

[Colin]

I use a 49 pound, 35 amp Astron Queen Mother VLS-35M. The front panel mounted meters and controls are real handy. They make up for the size and cost. You can see it here. (http://www.astroncorp.com/w28.html)

[TranceBear]

jeff_harrison_344 (Jul 20, 2001 09:37 p.m.):
Hey nice O/C!

And you too Colin!

Man I cant wait till I get my new 1Gig AXIA and MSI K7T Turbo with my CAK38

Nice setup Jeff!! Good choices

[App]

Wooow...after burning in my TB 1333 at 1576 I'm at 1620 (12 x 135 @ 1.85 V) now........and stable........Will see if I can get more out of this baby. After the last BIOS upgrade (Ver 1.4) this MSI K7T 266 mobo is really great!

[lemmingboy]

The best PSU for 156W pelts I have seen is the MFJ 4245-MV

They can do 45amps at 13.8 volts sustained, that will support two 156W pelts.

They run $180 and are small and light, you can pick them up from most Ham radio sales sites.

Here is one for you

http://www.noard.com/mfjpowersupplies.htm

[Tacoman667]

Interesting, but will the 156W run properly on 13.8v at around 20a?

[lemmingboy]

ya, they pull about 16amps each. If you only want one pelt you can find a cheaper and smaller amprage supply at the same kind of sites. I think you can pick up a nice 23amp supply for about $99, same 13.8V output.