Freezes

[Twister1234]

I m running atm barton 2500+ at 200x11,under 1,65 volt.
sometimes,my hole system freezes,and i dont know,if its because of the low voltage,or any other problem...
have tried to run prime 95 over night,next day,prime was,hm,dont know exactly,the program wasnt active anymore,but no failure message etc...
my temps are good,at 1,65 volt(37°C load),so i wanted to keep my voltage as low as possible...
have tried 1,675 volt,but systems keeps freezing...
anyone knows this problem,or could it be,that my ati 9500@9700 causes this problems,due to some new drivers,i have tested,an uninstalled after(3,7->3,8->3,7->3,9->again3,7,all omegas)?

[Twister1234]

hm,if i look on my voltage,mbm5 reads at 1,675 from 1,66 to 1,68...seems some kind of unstable,using levicom 420 W psu...

[Steven4563]

what timings have u got your ram at ?

[Twister1234]

hm,2,7 volt,in sync running at cl 2,5 and 6/3/3
its infineon 512 mb 400 mhz...

Edit:system was stable,but got a mobo rma...perhaps my settings have been lower,dont know exactly,but was stable...

perhaps i should try setting ram lower,thx,will post,if that was the reason,is there any programm,good for testing ram?

[Twister1234]

hm,systems runs stable in prime,for about 5 hours,than there is a failure,changed ram timings to 6 3 3 seems to work better,failure must be cause of low voltage...

[Tnick24]

yea try upping your voltage again and see if it still freezes