Question about my 1.2ghz TBird 266fsb

[Zerodrag]

I just upgraded from my 800tbird. my question is, how do you set it to run the 266fsb? or is it just suppose to be set at 133? i have a KT7a Abit motherboard, by the way. a problem i am encountering is when i set it to 133, my system wont boot up (no monitor signal)... but if i set it to 12x100, it will boot up fine. and last question... what's the default voltage suppose to be (including the i/o voltage also)? Thanx in advance for any advice.

[Amedeo602]

When the fsb is set to 133 it will go to 266 by default (gotta love ddr).

As for your system locking up, it could be your memory. Make sure you're using PC133 (if you took the memory from your old system, it could be PC100 and wouldn't necessarily be able to boot @ 133 fsb)

[Zerodrag]

It's PC133 memory. i believe i have infineon. btw, what's the default voltage suppose to be as well as the i/o? thanx in advance.

[Zerodrag]

Got it to run at 133 finally. changed the cas setting to 3 and set the ram slots to 8/10ns on all three (before, i had them all on TURBO). seems fine at 1.75v.