how's this look?

[dz]

planning to make a water block for my Shuttle (since I doubt many blocks are made for the 60x76mm mounts, and my roommate is a machining major). I planned out a block, and would like to know if it would work well, and how much flow I'll need and such.

plans here (http://nweb.pct.edu/homepage/student/SMIMAT64/WBplans.png)
image resized and grayscaled, now 140k or so.

[feyd83]

Will one of the innovatek flat flows not work?

[solo]

Zymrgy's block

http://home.attbi.com/~jmcook3/waterblock/shine.jpg
http://home.attbi.com/~jmcook3/waterblock/top4.jpg
http://home.attbi.com/~jmcook3/waterblock/top1.jpg
http://home.attbi.com/~jmcook3/waterblock/top2.jpg

your middle inlet looks similar, but the side flows are sorta hard to understand from teh pictures

maybe you can PM zymrygy for more info :O

[Korndog]

u can make ur own mounting with a drill and some stuff from ace/homedepot
i used to have a socket 423 p4 which barely has (at that time didn't have at all) any waterblocks
i got a thick piece of aluminum drilled two holes for the in/out for water, and 4 holes for the motherboard.
worked fine.
as for the block u drew, looks nice, but hard to make..
good luck on it though, let us know how it comes out

btw, if ur using fireworks for that image, u can export it as a jpg at about 1/10 of the png size.

[dz]

The angled (raised) parts by the outlets are to get the water to flow around the block more, and hopefully get a better balance between up/down and left/right flow