Winxp install troubles

Abit IS7-E P4 2.6c I screwed up the polarity on the led power indicators for the chassis. At least that what I think happened. I seem to have them straight now but when I go to load xppro after set up files load and the computer reboots to what should be the next install step,the set up files load again then I am back to deleting the partion and starting over it's like a bad dream! what gives Pls help and thanks for the time Marcxs

when it reboots and says it is booting from disk are you hitting any key to continue if you are dont, let it start by itself and should continue normally if that is not the problem give us some more info, any errors or anything happening

Doooh!!!

I had the C: drive jumper configured wrong Thanks for the reply Marcxs