SOShootME

[LPS]

It's extremely hard to plug the 1/2" 1/8" tube into the 3/4" heatcore there with hot water for the tube..
my finger...
i plug the 5/8" but 3/4" is very difficult..

[LPS]

finally..
i did it..
but put it in the boiling water..
like cooking the tube...

[Sneakytermite]

Good job man. Post some pics.

[LPS]

i wanna..
but my brother DC borrowed to friend..

[wildfrogman]

Hey, good job. Stretching hoses like that can be a pain. Also, you could just edit your first post...it shows you posted again 5 minutes after you posted the thread. What kind of pump do you have for your watercooling setup anyways?

[Yuriman]

I shortened both of the barbs, and cut off the 3/4" part with a hacksaw. It would make it a lot easier if you did too.

[SOShootME]

Hey there LPS,

I am glad you got them on. It was a difficult task for me as well. Since everyone here is always talking about optimizing flow rate, I couldn't see putting barbs on.

I even used the 5/8"OD plastic barbs for my ViaAqua 1300 pump. I thought for sure they would snap when I forcing the hose on, but they help together. :)

[ILikeMy240sx]

hey LPS. Glad you decided to this route! Next time, i mention this to other people. I will specifically say BOIL not heat... lolz sorry for not mentioning it