Removing Ramsinks?

cypher_138

Member

​

Joined

Mar 23, 2003

Location

NJ

• Dec 12, 2003

• #1

I epoxied ramsinks onto my 9800XT with Artic alumina epoxy with a little AS5. Whats the best way to remove them without damaging the card?

 

OP

cypher_138

Member

​

Joined

Mar 23, 2003

Location

NJ

• Dec 12, 2003

• Thread Starter
• #2

Never mind. I found that I've been getting a kink behind the fan when I put my panel on @ the GPU WB. I'll have to use a 90 to remedy it. I also figure the warranty is voided on this card as is so I pulled the shim off of it. I didn't think heat would cause the problem I was having.

 

Tawcan

Registered

​

Joined

Dec 17, 2002

Location

Vancouver, BC

• Dec 12, 2003

• #3

Howdy fellow SG member.

 

OP

cypher_138

Member

​

Joined

Mar 23, 2003

Location

NJ

• Dec 12, 2003

• Thread Starter
• #4

Hey Tawcan. I've seen a few post from you here and at EOC as well. You got to love a post where you answer your question before you get a response. I should have held off.

 

Tawcan

Registered

​

Joined

Dec 17, 2002

Location

Vancouver, BC

• Dec 13, 2003

• #5

cypher_138 said:

Hey Tawcan. I've seen a few post from you here and at EOC as well. You got to love a post where you answer your question before you get a response. I should have held off.

Click to expand...

Hehe~ Just browsing around...no more stay on one specific forum for me.