92 mm Vantec on a swifech

ZGOZZ

Member

​

Joined

Dec 4, 2003

Location

NJ USA

• Dec 20, 2003

• #1

What is a good fan controler for just the Vantec?

 

NiTrO bOiE

Member

​

Joined

Dec 15, 2002

Location

Charlotte, NC

• Dec 20, 2003

• #2

I use a the Vantec Nexus for my 2 deltas (same specs as tornado) and my Volcano 7+ fan and it works great.

 

OP

ZGOZZ

Member

​

Joined

Dec 4, 2003

Location

NJ USA

• Dec 20, 2003

• Thread Starter
• #3

So the yellow wire that comes off the fan, not the power would be hooked up to the controller for fan speed?

 

NiTrO bOiE

Member

​

Joined

Dec 15, 2002

Location

Charlotte, NC

• Dec 20, 2003

• #4

No, the yellow wire still hooks up to your motherboard for RPM sensing. The molex hooks up to the fan controller/rheobus.

 

OP

ZGOZZ

Member

​

Joined

Dec 4, 2003

Location

NJ USA

• Dec 20, 2003

• Thread Starter
• #5

NiTrO bOiE said:

No, the yellow wire still hooks up to your motherboard for RPM sensing. The molex hooks up to the fan controller/rheobus.

Click to expand...

When I hooked up the yellw wire to the motherboard it would not boot.
I wounder why?

 

NiTrO bOiE

Member

​

Joined

Dec 15, 2002

Location

Charlotte, NC

• Dec 20, 2003

• #6

The yellow wire doesn't power the fan, it's just to monitor the RPMs. You still have to hook the other cable up to a power source.

 

OP

ZGOZZ

Member

​

Joined

Dec 4, 2003

Location

NJ USA

• Dec 20, 2003

• Thread Starter
• #7

NiTrO bOiE said:

The yellow wire doesn't power the fan, it's just to monitor the RPMs. You still have to hook the other cable up to a power source.

Click to expand...

The power suply plugs I know.

But what I was saying , when I pluged the wire to the mother board, were the stock wires went the system would not boot.
Removed the wire from the mother board (yellow one that is for fan speed) system booted fine