O.K. guys, need som help kickin' this cC0 Celly 600 to a gig

[Sempei]

This chip runs 928(9x100 +2.5%turbo) at 1.65v perfectly stable. Have to jump to 1.9v to load Windows at 1008 (9X112). Ran Stability test for about 1-1/2 hours then blue screen. Don't really want to up the voltage any more if I don't have to. Using Alpha PEP66 w/ Arctic Silver paste on Abit BH6 w/ Abit Slotket!!! set to Coppermine and auto voltage with good case cooling. With the BH6, I can't monitor the chip temp but case temp never goes above 28C. Using PC100 memory set to 3-3-3. This memory runs perfectly at 103@928 at 2-2-2. Will burning in at 928 1.9v help any? Any ideas would be appreciated.

[Tim-]

Burn in often helps, but not as often as bumping the Vcore up a bit. If you have good cooling- cpu and case- the increased voltage isn't much of a threat. It may only run for 10 years instead of 15 but...

Good luck- 1GHz is tough for Celermines- only a small percentage make it. Honestly, you will gain more performance by getting some cas2 ram to run where you are, than you will get by going to 1GHz @cas3.

[flox23]

i have my 633 at 2.0 !!!

so go for 2.0 V !!!

burn in: high voltage low clock speed !!!!

flo