Can any one help please

[nystar]

I have a p3 slot 1 450mhz overclocked to 504mhz running on a ga-6bxc rev2.0 motherboard 300w
power supply
and 6 yes 6 fans, my question is how can i change the voltage as there is no setting on the mother
board

[vipez888]

nystar (Feb 12, 2001 10:04 p.m.):
I have a p3 slot 1 450mhz overclocked to 504mhz running on a ga-6bxc rev2.0 motherboard 300w
power supply
and 6 yes 6 fans, my question is how can i change the voltage as there is no setting on the mother
board

Well, assuming you have the p3-katmai core, and checked that there is no jumpers on the board or bios that allows voltage tweaking, another method is the pin taping.( Use very thin, but strong tape)

Below are the slot pins you must tape(you can find the pin numbers by looking at the top of the gold slot pins, usually located on the ends of the slot)

For:
2.2V, A121, A119, B119

2.4V, A121, B119, A120


Note: pins A are on side of the slot chip, and the B's are on the other side.


Good Luck OCing.