My new system

[dwillms]

Hey I just went out and bought a new system.

I threw my 2 p3 700's in (OMG it is hard getting the latch on, sure glad i put down electrical tape where I was attaching it cause i slipped once and could have damaged my board) ANYWAYS I put the chips at 133mhz fbs right off the bat, so Im at 933mhz each chip. Then in windows2k SOMETIMES on OCCASION i get bluescreen debug dump screen and then my machine restarts...Do you think that putting the voltage up would help? default is at 1.70 what would be better? and the chips aren't getting hot either 35-40c max... (oh maybe this would help if im running at 875mhz each chip the blue screen never comes....so its not a win2k problem i dont think)

Thanks for all your help....and Tim....you are like the best guy here, I see your replies in like every thread, but any help or suggestion i can get will be much appreciated.

-DWILLMS


Abit VP6
Dual p3 700mhz (both OC @ 933mhz)
512mb 133mhz micron ram 2x256 cas2
2x 46.1GB IBM Deskstar (set on ata100 raid0)
12x10x32 AOpen CD burner
16x Pioneer DVD
19" monitor FLATRON 915FTplus
Cambridge soundworks FPS1500 sound system 5 piece

[Tim-]

I have to run mine at 1.85v Vcore to be stable at 1002 and 1.8v to be stable at 933, so I would recommend that you try bumping the Vcore up a bit. Be sure to keep an eye on the temps though! Both my cb0s and my cc0s need the Vcore boost. ( I have 2 VP6s...)

Thanks for the kind words!