2.0 Volts..... too much???

[DaPuppet007]

I've been trying to get my CPU to run at 933mhz stable for about a month now with no success. What I did notice was that when I tried to run it at 2.0 volts the stability increased, ie. It would almost finish an entire cycle of 3DMark2000. I'm scared as hell to try higher than 2.05 volts, especially when the only cooling I'm using is a Chrome Orb. It has posted at 980 at voltages as low as 1.8volts, so why can't I get 933mhz stable? Oh well. Any help or a PLL for a Trinity 400 S1854 for SOFTFSB or CPUCOOL might be helpful.

P3 700@866mhz 1.75volts
Chrome Orb
Abit Slocket III
Tyan Trinity 400 S1854 <----I hate it.
Geforce 2 MX @ (235/215) Blue Orb

[marty]

I would seriously consider a software cooler and a better heat sink. I wouldn't go higher than 2 volts. It's your CPU so you can decide. But it there is a cooling problem, then you surely could fry it.

Do you need the URL for the CPU Cool or do you want someone to email it to you?? I don't understand that part of your message.

Here is one of Podien's URLs:

http://members.nbci.com/podien/

[DaPuppet007]

My question was if there is a PLL I can use for SoftFSB or CPUCOOL to change the FSB on my mobo. For sys specs look above.