alarm on be6llr2 when overclocking

[madmax]

ok i got my drivers install for ata66 on the be62r2 now i try to overclock to 933 and get a alarm , what happening i had this chip up to 933 on my old board bx6r2 so i change boards and i only can get 700 out my chip can any one give me the correct soft menu setting , your kindness will be appreciated.i got muskin 133 rev 3 ram gf2 pro vid card

[madmax]

my sys temp is 27c but my cpu temp is 62 c is this to high

[chris]

Your CPU temp is very high. I think Intel rate the hottest the 700, and most of the P3's can go to is around 70 degress C. Your chip seems way too hot!
What alarm are you talking about? I have 3 alarms on my Abit BX133 board. Board, system and cpu alarms. Do you have the Hardware Doctor program that I got with my BX? If you have and you havent checked that, then I would suggest taking a look and see if your max temps are exceeded. Have you set the maximum cpu temps in the BIOS ? Check there also.

[madmax]

ok my cpu was getting to hot , my fan was not fitting right on my cpu, got that taken care of and my temp went down to 49c , i need to get another fan.running now @980 stable