Switched Motherboards, Now getting horrible Quake3 timedemos!!! HELP!!!

[Carmine_Paterno]

I just got a ABIT BF6 and got my processor (Celeron II 700) to 1015 @ 2.2v. YEA YEA YEA i kno thats high voltage but now i am running it @ 903 1.7v (default cC0). I used to have it @ 877 on my ASUS P3V4X and got 116 fps in a normal timedemo 640x480. No i get 83!!!! The same thing happened to me until i updated my 4in1 drivers. Is there a type of 4in1 driver for the ABIT BF6? I kno it is just the agp driver. It has to be set to dma not to normal. Anyway i can set it? Any program? Anything just help!

[DocClock aka MadClocker]

are your agp/pic devices underclocked? What about the pci devider, and agp...could be you might need to set the pci to 1/3 instead of 1/4?
just a thought

[got_yogurt]

Are you sure that your AGP is running at 4x (or whatever the max is for your card)? may want to check that

[Tim-]

Have you tried different AGP aperture sizes in the "Advanced Chipset" menu of the bios?

[Carmine_Paterno]

Yup, i did all that stuff, and i even looked in the powerstrip where is says what mode it is using and it is already using DMA mode for the transfers. What is going on here? The max agp for my video card is 4x, the max for the motherboard is 2x. I have 2x enables. In the bios i have the fsb/agp divider set to 1/1 and agp set to "fast". What else can i do? The same thing happened to me until i updated my 4in1 drivers as i said b4. The only thing i didn't do yet was flash the bios. Could that be it, i don't think so.

[Carmine_Paterno]

Another thing, I get alot lower scores in Memroy benchmark, i used to get 320/260 now i get 290/330. What is with this? I guess the memory is explained because my memory was running @ 126mhz but now @ fsb speed (1015 ---96, 966 ---92)

Any tweaks for these mobos?