Having troble getting my block on stright.

There seems to be no stress on the block, but my temps are:

@ 1.93V @ 215x11; 2380 or so.

Around 39I-46L

Now is that high?

Right now I have the window open and with SETI running its at 43L, but that cuz its about 66 in here, rather than about 74.

I had to mess with the block the 1st few times. I was getting temps of 45I, and they would just keep climbing in bios, so I then clamped the block down almost all the way.

Do those temps look right? and is there any other tip besides do it in a "x" fashion?

Thanks!

Adam

Why does your sig say

Mag3, Dtek Spirial, Dtek Rad. 35I/41L

probably because he just overclocked some more anvil
those temps could be right, depends on your case

Well guys, I poped my CPU out and put a diode under my CPU..

Right now seti Full load:

MBM:

43C


The digi doc that came with my Xaser III:

38.8

Thats 5 degrees Celcius....... OUCH!

Which one is right?

Ive heard my board has terrible temp reading.

Its really hard to tell what ones is right. My load temps are 42c on my duron 1600@2430 1.85v on my nf7v1.1

They are about right at that overclock.

What I do is push the diode out so it sticks out above the socket, then put a little thermal goo on it, then press the cpu down on it so theres a good connection.

Jon