people pls share ur OC settings on a barton 2500+

[DaRky4YoU]

I revieved my stuff and wanna overclock it and be sure i use the right settings

amd 2500+ barton
abit nf7-s rev 2
corsair pc 3200 pro low latency
superflower 400 watt psu
maxtor 80 gb 7200 rpm 8 mb cache


What oc settings do you all use, to how high should i put my memmory?

[Hoot]

Here's a good starting point:

Softmenu III Setup
CPU Operating Speed: User Define
External Clock: 200
Multiplifier Factor: 11
AGP Frequency: 66
CPU FSB/DRAM Ratio: 6/6 or 5/5
CPU Interface: Enabled
Power Supply Controller: User Define
CPU Core Voltage: 1.65 or 1.675 to be safe
DDR SDRAM Voltage: 2.7 (gives 2.8 at the socket)
Chipset Voltage: 1.7
AGP Voltage: Default

Advanced Chipset Features
Memory Timings: Expert
Row Active... : 11
Ras to Cas... : 3
RAS Precharge... : 3
CAS Latency... : 2.5
System Bios Cacheable: Disable
Video Ram Cacheable: Disable
CPU Thermal Throttling: Disable
Enhance PCI: Enable
CPU Disconnect: Disable
AGP Transfer: What your card supports 2x, 4x, Auto if you dont know
AGP Fast Writes: If you card supports it then Enable.

Other good points:

If you don't use IR, then disable it.
If you don't use SATA, then disable it.
If you don't use the Parallel Port, then disable it.
If you dont use MIDI, then disable it.
If you dont use the embedded LAN card, then disable it.
If you don't use the embedded Audio, then disable it.


If that runs stable, then consider tightening up the memory timings slowly, say 2-3-3-11, if stable then 2-3-2-11, if stable then 2-2-2-11. If the original settings are not stable, you may have to use a little more Vcore to start off.

Hoot

[DaRky4YoU]

thx man

[Axis]

see sig.