- Joined
- Aug 3, 2003
ok, so bascially, i'm trying to integrate the principle of a cold air intake on a car to my radiator. the radiator fans are drawing air from inside the computer, which is ~7*C greater than the air outside the case. So if the rad fans draw cooler air, the exhausted air will be able to transfer more heat out of the system... not to mention if there is a solid seal on the duct and it is heat resistant, it will not take on much of the ambiant case air.
Also, with this setup, the other intakes could be used to arranged in a push/pull to better cool the case (instead of the current push/push to sent enough air to the rad fans.
My radiator is top mounted with two 120mm vantec stealths fastened to a gladware full size entree dish (nice fit!)... anybody have any suggestions for a material to create a duct from one of the 5 inch bays to the 2 rad fans?
.________________radiator__
|......................|fan1 | fan2|
|.......................\_________| <--duct
|......................................|
|......................................| Front of case
|......................................|
|......................................|
|.........._..........................|
|.........|_|..side intake........|
|......................................| <-- front intake
|......................................|
|________________________|<-- front intake
the ...'s represent me being bored
I'm thinking maybe some fiberglass and epoxy.
any ideas are welcome
-David
Also, with this setup, the other intakes could be used to arranged in a push/pull to better cool the case (instead of the current push/push to sent enough air to the rad fans.
My radiator is top mounted with two 120mm vantec stealths fastened to a gladware full size entree dish (nice fit!)... anybody have any suggestions for a material to create a duct from one of the 5 inch bays to the 2 rad fans?
.________________radiator__
|......................|fan1 | fan2|
|.......................\_________| <--duct
|......................................|
|......................................| Front of case
|......................................|
|......................................|
|.........._..........................|
|.........|_|..side intake........|
|......................................| <-- front intake
|......................................|
|________________________|<-- front intake
the ...'s represent me being bored
I'm thinking maybe some fiberglass and epoxy.
any ideas are welcome
-David