How does this heatercore look?

Chez · Jan 27, 2004

I have seen this heater matrix for sale and am thinking about getting it to use as a rad for my P4 WC setup.

Does it look like it would do a good job?

The inlet and outlet are 1/2" and it is roughyl 13" long, 4" deep and 2" wide.

I was thinking of putting it in an external Radbox.

Thanks
Chez

simpleman · Jan 27, 2004

it looks old and rugged, but it looks kool
i think it would do great

ILikeMy240sx · Jan 27, 2004

I like the fact that its a single pass.. A lil on the smaller side but for a P4 setup it will do... If you are going with an External setup maybe you might want to consider a bigger single pass core since your space is not limited much only if you can easily get your hands on them...

AngryAlpaca · Jan 27, 2004

Looks good. It has a lot of surface area, and single pass is good.

craneage2001 · Jan 27, 2004

That's about what I've got...it's about the same surface area as the chevette cores that ,any use, plus it's singler pass. Should work pretty good.

AngryAlpaca · Jan 27, 2004

13X4 is larger than 6X6.

craneage2001 · Jan 27, 2004

yes, i realize that; I wasn't sure if he was only measuring fin area though...

Koooler King · Jan 27, 2004

That heater / radiator looks pretty "kick butt". If it holds water OK, I think it would work very well with a decent fan or fans ( with air tight shroud). Good luck!

KK

iNSiGMA · Jan 27, 2004

simpleman said:
it looks old and rugged, but it looks kool
i think it would do great

rugged... hahaa

How does this heatercore look?

Chez

Member

Attachments

simpleman

Member

ILikeMy240sx

Member

AngryAlpaca

Member

craneage2001

Member

AngryAlpaca

Member

craneage2001

Member

Koooler King

Member

iNSiGMA

Member

Similar threads