cpu diode

[makaka]

i have question i am trying to overclock a barton 2500+ of my feind hi have like an asus bord with volcano 11+
when i have set the vcore to 1.70v after stress test using prime 95 i
the cpu temp is 44c
and diode at 66c~67c ( using motherbord monitor)
when i try to push the voltage higher after 5 min of strees test 70c the cu diode temp and cpu at 49c
i turned off the computer to not domage the chip
what may be the probleme the diode are doing two high show it try another heitsink or what?
THANKS for help

[makaka]

no help??? :(((

[Sentential]

MBM show some screwy temps some times. I would trust whatever the BIOS says.

Hell Ive gotton 273c* and -540c* before.

If you gotta be sure but your hand on the heatsink. If ur skin dosnt peel off :D then its not 70c*!

[Gnufsh]

If the "CPU Temp" is reading from the insocket sensor, and the diode is reading from a correctly calibrated on-die diode, I'd say you are a little warm. The highest my overclock has hit has been 52C on die (My pally did 32c on die full load at 1810MHz). I definately don't like my temps even tat high. 67C-70C ondie temp is probably causing a loss of stability. Better cooling is in order here.

[makaka]

Sentential: mother borad monitor read the same as in the bios for the diode temp .thanks

thanks a lot for information i will try to find for him better cooling