need a way to make my waterblock taller.

sandman001 · Feb 6, 2004

Alright, I have a Maze4gpu, and it doesn't fit over ramsinks very well.

I need a way to make it taller that will only require a few hours.

Like, I have a maze3AMD coldplate here, could I just add that under it?

I mean, I know it wouldn't transfer heat as well, but I need this so my hoses will go on better.

vonkaar · Feb 6, 2004

Gah... I'd just as soon lose the ramsinks before sticking a half inch of heat-insulation in between my block and the GPU.

sandman001 · Feb 6, 2004

Well, I would, but I'm afraid it'd rip the ram off.

Plus, this ram runs really hot.

JFettig · Feb 6, 2004

The cold plate is a possible idea, youll probably loose efficiency a little bit, or maybe even quite a bit. But couldnt you just trim down the ramsinks?
I supose of they are on the card that might not be a very good idea....

Jon

sandman001 · Feb 6, 2004

Well, I figure for running stock speeds it'll be fine, right?

sandman001 · Feb 6, 2004

Well, it's on there.

I'm almost sure it will be fine to just run the card with, right?

I mean, this is kind of a speak now or forever hold your peace kinda thing.

Fast420A · Feb 6, 2004

just go ahead and stick a peltier in there

need a way to make my waterblock taller.

sandman001

Just Freeze It

vonkaar

Member

sandman001

Just Freeze It

JFettig

Hey! I showered! Senior

sandman001

Just Freeze It

sandman001

Just Freeze It

Fast420A

Member

Similar threads