Newbie - o/c query

[chaos_ad]

After reading some articles here i decided to do some o/c and have come to a screeching halt
have P2400 clocked to 468Mhz on an Aopen Ax63 Mobo (Multiplier 4.0x, FSB 117Mhz ).My motherboard supports overclocking and is jumperless setup so i can change stuff in bios.
But here's my problem when i try FSB of 124Mhz with 4.0x , saving and exiting bios my system shuts off the screen and doesn't do anything, then i have to Hold HOME key at startup to reset defaults.
Is this a voltage problem, and if so my mobo has auto voltage, where do i change it??

[batboy]

Yes, it's the classic "needs better cooling and more voltage" heartache. You are describing what we call: "not posting or booting" and I'm afraid that might be a brick wall for you with that current setup. At best, try some low budget cooling mods, maybe you'll get lucky. Is there no motherboard FSB settings in between 117 and 124? Good luck.

[Howard]

I don't know much about your board to be honest, but I was wondering what your AGP and PCI dividers are set on.

PIII 700@1030 w/alpha, Abit BE6 II, Mushkin 256 Rev 2.0