P111 450 @ 558

[Digi]

Hi all had this running about 4 days now M/B is abit BH6 v1.1 settings are as follows
External clock 124mhz
Multiplier *4.5
Sel 100/66# signal High
Agp clk/ CPU clk 2/3
L2 Cache latency Default
Speed error Disabled
an any 1 tell me if these settings are right for this board am running on PC100 sdram 128 meg will upgrade to 133mhz ram if board will take it at the Moment i am just using standard cooling my question is will it be ok at this speed and for how long at this setup are there any other changes i should make in the bios or is this correct as it is my system also has Hercules 3D prophet 2 mx 64 meg Graphics agp sound blaster 128 pci,Scsi pci,Modem pci
Any help much appreciated Guys

Cheers Newbie Digi from the UK.

[[OC]Lucifer]

Well, most of the stats sound good, except I would take the cache latency down to 1 or so... maybe 0 if you can... it may make a negligible performance difference, but it may allow you to overclock more, or do what youre at more stably. Also, what is your voltage? make you watch it, especially with stock cooling. But other than that, congrats. A good overclock altogether. Especially with an older PIII. :)

[Digi]

Thanks for the reply Ltrey will give the latency a go machine runs at average 34* all the time even in 450 default mode,the voltage is 2.0 never changed it from standard.

Digi.