P4c800 (dx,e, e-dx) users. Here's a great oc tip.

Ok guys. I have a p4c800 deluxe board and I just wanted to say that I gained about 200mhz overclock on my 2.4Ghz by turning performance mode from auto or turbo, to standard. Not pat, just the setting in the jumperfree bios section. The one on the bottom.

Turbo doesnt even post on my machine but i have seen very very small increases in performance from it so the benefits of turning it off are much greater. Also, I have a problem that I can run my ram by spd timings as long as I set them manually and make sure that the spd option is set to "disabled". Otherwise...well...not go.

Good luck guys.

hmm strange.. check my settings below.. no probs on pam/mam, both enabled prolly its ur settings