Need help with a Celeron 633

[Wicked Klown]

Fist I just started overclocking. So far i can get my 633 up to 713MHz. But I want to go just a little higher. My MoBo is a Aopen AX34 II. Any help would be nice.

[The Doors]

Welcome Klownin79,
you can rise Fsb up to 100Mhz, or more, with your chip for 950Mhz!
but your Cpu need of a great Cpu cooler (forget Oem and Orb!), a thin layer of thermal paste, MotherBoardMonitor, to monitor temps, and a voltage of 1.8/1.85v if I remember well :-)
Take a look to the Cpu Database about yours, for more OC info.

I hope it helps you.

[AmbientFiction]

Going right to 100FSB could be a bad thing. Take it one FSB ster at a time on 66MHZ FSB I have a 633.

[Wicked Klown]

Ok i have just one small prob my FSB speeds are only 66 73 and 81 but i have jumpers on MoBo where I can change the FSB/PCI to either 66~83 , 133~150 or 100~124 but when i move the jumpers my puter turns on but the screen is black.

[AmbientFiction]

Klownin79 (Jul 18, 2001 02:59 p.m.):
Ok i have just one small prob my FSB speeds are only 66 73 and 81 but i have jumpers on MoBo where I can change the FSB/PCI to either 66~83 , 133~150 or 100~124 but when i move the jumpers my puter turns on but the screen is black.

Ok 66 and 73 are good most pci buses hates to be run at 81 so then you might try going to 100 if 71 is stable as a rock just have a good heatsink and plenty of air moveing through that case