- Joined
- Mar 4, 2003
I want to put a watercooling setup into an Antec Lanboy case, I realize its gonna be a tight fit, but I think it can be done. The box will consist of Max 3 mobo, 2.8c, 9700pro, audigy zs, network card, 2 harddrives, 2 cd drives and a floppy.
The cpu and the 9700 will be watercooled, and id like to cram a chipset block in there too, but im not sure there will be enough room.
Im gonna need a fairly small pump with reasonable good power, anything large is out of the question, so no iwaki or ehiem 1250. I was thinking about a mag 3, which will go under the drive cage in the front or in front of the board below the vid card.
the main problem is where to mount the rad, there's only enough room for a single 120mm rad, and no way that it will fit under the drive cage in the front. i was thinking about attaching it to the back, but then it would be difficult to rout the tubes properly. I want to get it like this: pump->rad->cpu->vid->pump
anyway, someone give me some suggestions on how i can make it all fit. Im sure it can be done, just gotta figure it out.
also, would 3/8 tubing be more flexible? theres likely to be some tight turns, not sure if 1/2 will be able to make it]
The cpu and the 9700 will be watercooled, and id like to cram a chipset block in there too, but im not sure there will be enough room.
Im gonna need a fairly small pump with reasonable good power, anything large is out of the question, so no iwaki or ehiem 1250. I was thinking about a mag 3, which will go under the drive cage in the front or in front of the board below the vid card.
the main problem is where to mount the rad, there's only enough room for a single 120mm rad, and no way that it will fit under the drive cage in the front. i was thinking about attaching it to the back, but then it would be difficult to rout the tubes properly. I want to get it like this: pump->rad->cpu->vid->pump
anyway, someone give me some suggestions on how i can make it all fit. Im sure it can be done, just gotta figure it out.
also, would 3/8 tubing be more flexible? theres likely to be some tight turns, not sure if 1/2 will be able to make it]