- Joined
- Aug 14, 2001
For over a week now I've been unable to get this board stable at anything other than optimized defaults. I started out with a DLT3C 1800 juihb 0331 and had absoultly no luck what ever. So I took an unlocked barton 2500 out of my nf7s and swaped the two. The nf7 doesn't care, even with mushkin 222 3200 it took the DLT3C to 2400 on the first try (the barton ran 2400 stable), Stable prime. The ultra constantly reboots either the 2500 or the 1800. I flashed to n24id121 and still have the same problems. Any OC over optimum default results in reboots at any given time. Temps idle are @38c Can't tell what load is cause it reboots before heating up.
2500 Barton 0331 @1.9
3500 mushkin lvl2 @3.1vdimm 2,2,2,6
chipset set @ 1.8
AGP @ 1.6
apic is disabled
50% cpu throttle or disabled (doesn't matter)
Anybody got any ideas?
Anybody know the beep codes? The manual doesn't give hardly any info.
2500 Barton 0331 @1.9
3500 mushkin lvl2 @3.1vdimm 2,2,2,6
chipset set @ 1.8
AGP @ 1.6
apic is disabled
50% cpu throttle or disabled (doesn't matter)
Anybody got any ideas?
Anybody know the beep codes? The manual doesn't give hardly any info.