P160 power led connector to NS7-S

[MaxAMD]

I have started putting my new system togerther:

Abit NS7-S 2.0
Antec P160 case

However the power led from front panel is 2 socket 2wire the mainboard has a 3 pin connection with no pin in second postion.

Can you buy this type of connector at like Radio shack or (where?)

Second (?)

Front panel connectors for sound & mic. Did you connect it on the NF7-S at the FPIO2 Header. Where did you put mic-bias wire and what is RET-R & L and where would they go?

Thanks.

[oblivi0n]

Theres another thread about this somwhere - but basically you just have to split the wires = and put them on the 2 pins.

I beleive(50% chance of being right heh) that is white left, green right.

I had the same problem, and I popped the pins out of the connector and just put them on the MB pins manually. Works fine now.