yaaayyyy over 1 Ghz

[ymNA]

I am so happy to get my baby over 1ghz. It's at 1017mhz right now (107 x 9.5 and 1.9cv) it's idle at 30C and load at about 42C. I am using the cheap thermal geese stuff. at this temp you guys think I can go higher? oh yeah it is still stable after the sandra burning test.

[NeoMoses]

Push it harder!!! those temps sound ok, you should be able to squeeze some more MHz's out of it.

[Alex99]

Yeah push harder, she's just warming up. Give her a few more knotches.

[ymNA]

sure will, but everytime I push up the bus speed above 120 or so, it will not boot, not even to bios. had to reset the bios everytime that happen. wonder why

[FRANK]

Congradulations!

that sure makes for a pretty good rush when you take a $50.00 processor to over 1000MHz doesn't it?

[oc jason]

drop the multiplier and then see what the FSB will do id try 8x133 first and keep going-may need to pencil in the L7 bridges to up the voltage but the temps are good

[WillysNut]

I haven't been able to post over 1050 but that's at 1.85v. I'm not quite ready to perform a voltage upgrade on my KT7AR. Your temps look really good right now. Give it a shot..take it easy, and find the limits of your current setup. Congrats on the 1Gig OC!!

[phiber]

congrats on the OC i remember when i got my duron over a Gig

[ymNA]

i guess i have to stop at 1017mhz, cus can't get my bus to go over 107 with the muilti. at 9.5. I tried to lower the muilt. and higher the bus still can't get over 1017. It eighther can't boot or blue screen when start up :(

[kentank]

congratulation man...

use fsb 133 may be you can reach
higher with that temp...

i can only get 137 MHZ......arrggghh