- Joined
- Jan 30, 2003
- Location
- Atlanta, GA
I need some serious help here. Check it out, I just finished up work on my upgrades for the rig in my sig. I get the system going after a voltage tweak on the PSU.
When I booted up the system, I was excited. But, soon after when I started to raise the FSB, it just would have it. I lowered the Multi and that helped a little, but I didn't want to go that low( 8-9) I don't what the problem could be. The RAM is BH-5 so I know it will run high FSB's and the processor is a AQYFA 0343 chip that is known to be a decent OCer. I just can't figure it out.
I need some help here and any help proved is greatly appreciated.
THX,
bafbrian
When I booted up the system, I was excited. But, soon after when I started to raise the FSB, it just would have it. I lowered the Multi and that helped a little, but I didn't want to go that low( 8-9) I don't what the problem could be. The RAM is BH-5 so I know it will run high FSB's and the processor is a AQYFA 0343 chip that is known to be a decent OCer. I just can't figure it out.
I need some help here and any help proved is greatly appreciated.
THX,
bafbrian