WHere to buy door w/windoew for Mach II w/ Enlight top?

[WA2]

I just got my Mach II tonight...wOOt!!! I want a window door for the Enlight case. I dont want to do it myself (I hate cutting..done it to many times). I found a modded Enlight called the "somethign Breeze" that has the correct door, but where do I buy it?
Enlight EN-7230 (or 7238)

[mtb856]

What did you use when you tried it before? Dremel, jigsaw... I used a jigsaw with a high tpi blade- 21tpi i believe- and it wasn't hard at all, even with the tight turns. you might check directron, sometimes they have premodded windows.

[WA2]

Dremel, it sucked for some reason.

[mtb856]

I'd imagine that it would be freaking slow. It took me 2 hrs with the jigsaw. Do you have one, or know someone that you could borrow one from?

[WA2]

Yeah, thats a window.....*shakes head*

I dont need to know what they look like, or how...I know all of these. I need to know WHERE to buy.... :mad:

:D

[eobard]

Originally posted by WA2
Yeah, thats a window.....*shakes head*

I dont need to know what they look like, or how...I know all of these. I need to know WHERE to buy.... :mad:

:D
Then this shouldn't have been put in cooling (or it's duplicate in extreme cooling). It should be in either Alt Modding, Cyber Deals or possibly Vendor discussion.

[WA2]

What a great choice of forums to put this in. Maybe you could just delete it..will get about the same response being in this forum. :rollseyes:


Only forum I have been to where the mods/admins have such attitudes.

[asdasd]

i'm not sure its the mods/admins with the attitudes...
your eye rolling didn't come out quite right either

[tbones1337]

i tried using a jig saw, even on low it would kick up and holding down the sheet and the saw is hard..

Yank out me dremel.. 30 minutes and im done. I did a blow hole perfect in 15 min ea (one in the Side acrylic side, and on top which was metal).

I would use a dremel.. also if its taking long due to the cutting disc. i went and bought some more (ran out) and they were dremel brand and were thicker, then the ones i had, which is craftsman (they make my dremel) and they cut better than the damn thinner ones. you can get @ home depot too a carbide blade. its all metal looking about 14 bucks and wont break and cuts like a regular disc but in 1 piece in the end.

[mtb856]

Hey WA2,

Chill dude, I was just giving you some alternate ideas to spending your money on a premod. Like I said, you could try Directron. As for the Enlight Breeze, its a premod case that you can buy from xoxide.com . You could email em and see if they'll give you the door with the window in it, but you'll have to see about that.

[shard]

my dad says that for the best metal cut to use professional metal snips. and make sure they are sarp. yu would be amazed at the perfection that comes from doing it that way!