- Joined
- Dec 11, 2003
I am prime95 stable using 2 instances of Large FFT. 1 Instance at realtime priority and the other set to High so it doesnt lockup the pc.
At 233mhz FSB it reboots after a few minutes doing the exact same test. At 232mhz it locks up when it reaches 12 hours into the same test. Is this a ram issue being that its at its 1:1 limit or a NB heat issue? I have the AGP voltage set to stock which also controls the NB voltage. Could this also be a case and if so wouldnt this hurt the video card if I increase its voltage?
------------------------------------------------------------------------------------------
I just now did a little playing around with the AGP voltage. I set the FSB to 240 and the agp to 1.6 and it wont post. When I set it to 1.7 it goes to the windows logo and blue screens afterwards. I then reduced it back to 1.5 since that obviously wasnt stable.
any sidjestions?
At 233mhz FSB it reboots after a few minutes doing the exact same test. At 232mhz it locks up when it reaches 12 hours into the same test. Is this a ram issue being that its at its 1:1 limit or a NB heat issue? I have the AGP voltage set to stock which also controls the NB voltage. Could this also be a case and if so wouldnt this hurt the video card if I increase its voltage?
------------------------------------------------------------------------------------------
I just now did a little playing around with the AGP voltage. I set the FSB to 240 and the agp to 1.6 and it wont post. When I set it to 1.7 it goes to the windows logo and blue screens afterwards. I then reduced it back to 1.5 since that obviously wasnt stable.
any sidjestions?
Last edited: