• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Help Me Decide Which Mobile XP to buy

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.
J

Jen

Member
​
Joined
Dec 24, 2000
Need a couple for my MSI K7D Master L dual motherboard. Would like something that will oc well at very low voltage. Summer is here in California and my room temps are going up very quickly.

I see so many steppings and dont understand what is overclocking the best.

ExcaliberPC



Hugs


Jen
 
anyone order any 2600+s from excaliberpc lately? if so what ones are the best results?



Jen
 
This is mostly likely your best bet

AMD Mobile Athlon XP2600 Processor(Tray) (IQYHA:0351MPMW)
$105.00


Personally I woul just get the cheapest mobile 2500+ you are running a dual system, so you won't be able to max the chips out.

The 2500+ have been beating the 2600+ from the start.
 
AMD Mobile Athlon XP2600 Processor(Tray) (IQYHA:0351MPMW)
$105.00
Click to expand...

I second that check sig :). It's the same stepping. Will run @ 250x10 @ 1.75V Prime stable for 24hours (and will loop 3DMark2k1se all night). Full Load 40C.

Psyko
 
XP2500 (AQYHA:0410TPCW) gets my vote...

a few people at XS and a few people here have a 410 and they are getting between 2.6 - 2.7 on air...and run cooler at more voltage

The 2600's average around 2.6 - 2.65 on air...can run at 2.6 between 1.75 - 1.8v...but to get 2.65...takes around 1.93v+...and also seems to hate anything past 49c for long...(I run a 2600 from Ex)...
 
glock19owner said:

and also seems to hate anything past 49c for long...(I run a 2600 from Ex)...
Click to expand...

Thank you so much for saying that.
Every time i say over 45C is too hot, more often than not i get flack.

once again, more proof stable computer run 45C or cooler
 
glock19owner said:
XP2500 (AQYHA:0410TPCW) gets my vote...

a few people at XS and a few people here have a 410 and they are getting between 2.6 - 2.7 on air...and run cooler at more voltage

The 2600's average around 2.6 - 2.65 on air...can run at 2.6 between 1.75 - 1.8v...but to get 2.65...takes around 1.93v+...and also seems to hate anything past 49c for long...(I run a 2600 from Ex)...
Click to expand...

were the 0410 "TPCW"?
 
I got a 0410 TPAW and I'm wondering what's the dif with the TPCW

currently in the process of OCing it so don't know if it can affect OCing ability
 
thank you everyone for the suggestions. i'm looking for 2300mhz overclock with very low voltage with processors that can handle heat


hugs


Jen
 
My 2600 does 2.2 at 1.45v (default)...and 2300 at 1.55v...Obsoletes 2500...the one I linked above...does 2.3Ghz at 1.5v...

My system:
NF7-S rev 2.0
SLK-900A w/92mm tornado
2x256 Kingston Value Ram
9800 Pro (412/365)

Obsoletes:
DFI LP rev b
WC setup
2x512 Kingston Hyper X
9800 Pro (412/365)

SIDENOTE:

I still out perform his system when running at 11x248 vs 11.5x225...I get about 100 to 200 more marks then his setup...
 
glock19owner said:
My 2600 does 2.2 at 1.45v (default)...and 2300 at 1.55v...Obsoletes 2500...the one I linked above...does 2.3Ghz at 1.5v...
Click to expand...

thank you for your help ,


i notice excaliber is now listing a IQZFA stepping for a 2600


hugs

Jen
 
i will be placeing a order for two of these later today

XP2500 (AQYHA:0410TPCW)


now have to figure out what is best method to disconnect the one extra bridge for SMP use


Jen
 
You must log in or register to reply here.

Similar threads

funsoul
Need build oc help (5900x, 3600 b-die, 3090ti)
Replies
16
Views
2K
funsoul
funsoul
Al_bundy
Alucryl - 3DFX - CNC - Retro pc
Replies
2
Views
372
EarthDog
EarthDog
H
Newbie looking for help overclocking GTX 1080
Replies
1
Views
749
wingman99
W
FriX
Aorus gaming 7 x370 with F10 strange dynamic v-core values
Replies
5
Views
463
Johan45
Johan45
DeathAngelLST
Help me decide what to upgrade to
Replies
14
Views
902
DeathAngelLST
DeathAngelLST
Back