My Mach 2 just arrived from Kit-Tronics, its been set up properly- my Xaser 3 has been moded nicely for it. Everything has been done correcly, when I plug in the power cord the green LED blinks likes its supposed too.
But when I press the power button nothing happens. It doesn't start up and the yellow LED does NOT blink. During shipping the chip at the back got shaken off along with two of the wires going to it. I'm almost positive the wires have been reatached correctly but if thats the case then the units defective. If someone could post pictures of their chip and give any help they can that would be fantastic. I looked everywhere on the net for instructions on the control chip but couldnt find any.
Thanks in advance.
But when I press the power button nothing happens. It doesn't start up and the yellow LED does NOT blink. During shipping the chip at the back got shaken off along with two of the wires going to it. I'm almost positive the wires have been reatached correctly but if thats the case then the units defective. If someone could post pictures of their chip and give any help they can that would be fantastic. I looked everywhere on the net for instructions on the control chip but couldnt find any.
Thanks in advance.
Last edited: