Bare Wire

[youthemandan]

How do i hook a bare wire fan up to my PSU.

[JoeC]

You can splice it into the yellow and black wires (assume it's 12 volts) from a four wire connector.

[Richard]

Stop by radio shack and pick up some 4 pin molex connectors.

The yellow is the 12 volt line. Black is your ground. Look at the molex connectors coming off of your power supply to get an idea of how to hook it up.

[Da Whip]

You could pot them, coat them w/ solder and slide them into the proper connectors on a molex.

[youthemandan]

http://www.deltaww.com/products/dcfans/pdf/AFB92254.pdf
This is the fan i'm getting its a AFB0912HH and it seems to have red and black wires not yellow and black. Whta's the diff.

[The Coolest]

The red wire on the fan is the positive pole and the black is the negative, the red wire goes into the yellow wire on your PSU and the black to the black wich is the closest to the yellow.

[William]

you can also buy a fan bus if you have several of these fans and hook them up the psu like that. Just depends. I spliced some wires together for my delta.

[TheMortalWombat]

Actually it doesn't matter wich black wire you connect your fan to.