At a loss!

[Tarowah]

Ok my system is in my sig so I wont post all the stats again.


When set my system at 333/250 fsb/ultra turbo mode IE 5:4 everything runs fine but I lose a good deal of memory bandwidth due to the lower memory speed, but when I set my system up at 400/250/ultra turbo IE 1:1 my system runs everything but games like a champ, no lock ups, no problems at all.


When I atempt to run games set at 1:1 with all of the video settings defaulted or overclocked, my video looks as if the memory is overclocked too far, I get blinking textures and massive tearing, when I revert back to 333/250/ultra turbo I have no problems at all, I have changed everything I can think of to figure this out before I posted, voltages, timings etc etc etc.


Any help would be great!

[lansens]

Be sure you have your pci bus locked at 33/66.

[syberspy9]

33/66 for shure try bumping up the vcore 1 notch (might work if not go back to what u had it at)

whats ur DRAM voltage?

[Tarowah]

I havent updated my sig yet, but my Neo2 LS board had a bad NIC so I went to trade it in and they were out of stock, so I have a 865G-PLS now, G chipset is a little slower from what I had ,but it works =)


My ddr voltage is at 2.8 when I try to go 1:1 (400/250), I have tried from 2.6 volts to 2.85 volts but I still get the nasty tearing in games.

My AGP/PCI is locked at 66/33, only thing I can figure is I got some low end PC4000 HyperX, I start getting the artifacts at 220 FSB and 1:1, not going to gripe a whole lot, at 333/250 (5:4) I still geting 5200/5200 in Sandra mem bench, but MAN that 6100/6100 would be sweet.