- Joined
- May 19, 2004
I bought a heater core today with the given dimensions as 7.5 x 6". When I measured it, sure enough it was 6" wide, but more like 9.25" tall. What gives? I tried measuring just the finned part, but it was a little over 7.5". Is that height given the height for just the finned part or was the hc I bought labeled by morons?
Suffice to say, the hc didn't fit.
I've been searching for hcs online and I found two sites that have been very usefull. I'm sure they've been posted here before, but I don't think anyone would mind too much if they were posted again.
http://www3.telus.net/MadHacker/HeaterCores.htm
(I ripped this off of someone who is being kind enough to host. I forgot who, but if you're him and don't like it, I'll take it out)
http://www.autopart.com/radiatorinfo/heatercoretech.htm
Suffice to say, the hc didn't fit.
I've been searching for hcs online and I found two sites that have been very usefull. I'm sure they've been posted here before, but I don't think anyone would mind too much if they were posted again.
http://www3.telus.net/MadHacker/HeaterCores.htm
(I ripped this off of someone who is being kind enough to host. I forgot who, but if you're him and don't like it, I'll take it out)
http://www.autopart.com/radiatorinfo/heatercoretech.htm