http://spanko.shackspace.com/mysexycomputer.jpg
I run my 2.6c @ 3.25 1000, using a 5:4 ratio on my ram. Voltage is 1.65 set in bios. Full load temps are around 36.5C. I have the one fan running half speed? Pushing air into the radiator.
Flow is eheim 1250-> Dtek ProCore-> Cascade-> T-> Eheim. Im not really happy with the setup to be honest. Its kinda loud, and a total pain in the butt to do anything in the case, even moving cables, much less taking out the videocard or anything else in that area. The case is your standard pc70, 2 front 80mm, 2 rear, then the 1 120 at the top. The sounds of the fans is a little too loud for me, then theres the raptor =/. Im thinking about redoing the whole setup with one of the new dtek jr pro cores, 2 120mm fans and 2 shrouds, with both fans running really low. And i wanna swap out the eheim 1250 for something smaller, like a MCP600 or the Cool Technica version with the modified inlet/outlet so i can keep using my T res. I also need to get a dremel, anyone wanna reccomend me a good one? Anyway any ideas/critiques on how to improve would be greatly appreciated!
And also i havent really tried to OC more yet, so i dont know if i can higher then 3.2.
I run my 2.6c @ 3.25 1000, using a 5:4 ratio on my ram. Voltage is 1.65 set in bios. Full load temps are around 36.5C. I have the one fan running half speed? Pushing air into the radiator.
Flow is eheim 1250-> Dtek ProCore-> Cascade-> T-> Eheim. Im not really happy with the setup to be honest. Its kinda loud, and a total pain in the butt to do anything in the case, even moving cables, much less taking out the videocard or anything else in that area. The case is your standard pc70, 2 front 80mm, 2 rear, then the 1 120 at the top. The sounds of the fans is a little too loud for me, then theres the raptor =/. Im thinking about redoing the whole setup with one of the new dtek jr pro cores, 2 120mm fans and 2 shrouds, with both fans running really low. And i wanna swap out the eheim 1250 for something smaller, like a MCP600 or the Cool Technica version with the modified inlet/outlet so i can keep using my T res. I also need to get a dremel, anyone wanna reccomend me a good one? Anyway any ideas/critiques on how to improve would be greatly appreciated!
And also i havent really tried to OC more yet, so i dont know if i can higher then 3.2.