• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Danner Mag 7 Fittings Q???

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.
you need to get barbs. I have the Mag3, and if the 7 is like the 3, then you need to get one 1/2" barb that threads INTO a female 1/2" thread, and one 1/2" barb that threads OVER a male thread. Home Depot or any hardware/plumbing store should carry these.
 
but i noticed on the Mag that on the inlet the threads are in the inside and on the outlet the threads are on the outside but both the sizes are 1/2"...
 
i think but i don't kno i just need a specific answer tho

EDIT: The Mag line of pumps are both submersible or external magnetic drive water pumps. The mag 7 has a 1/2" female input and a 1/2” male output. A flow rate of 700 gph can be acheved at 0' head.


i found this if this may help to get me the perfect fittings for this pump
 
would something like this work its 1/2" and it'll screw into the Inlet
187400.299x299.jpeg
 
Back