- Joined
- Dec 11, 2003
- Location
- Northeast Ohio
Parts I decided to purchase
Danger Den TDX CPU Block
1/2 Fittings
Radiator Black Ice Xtreme Blue II
10 Feet Tygon Tubing
Bay Rez Dual Floppy 3.5 Bay Reservoir
Maze 4 GPU
Swiftech MCP-600 12volt Pump Rev.II
Here is a link of my case and all of it's air components atm.
http://www.ocforums.com/showthread.php?s=&threadid=274848
Was thinking of moving the bottom harddrive next to the top one in pic. Should leave enough room for Dual Floppy 3.5 bay reservoir. Modded my case with 80mm blowhole with window. Was thinking of modding a new window on top of case with 2 120mm holes. Was going to move my cd rom and cd-rw drive on two bottom 5 1/4 bays. Is there any way I can mount the Black Ice Xtreme II Radiator in the top two 5 1/4 bays having the 2 120mm fans pulling the heat from the radiator out of the newly modded window with the two 120mm blowholes. Problems I am thinking I may encounter is equipping the shroud and fans equipped on radiator and getting enough clearance to run tubing without kinking the tubing. Any suggestions if this will work or better ideas to set up this watercooling system with my current case?
Danger Den TDX CPU Block
1/2 Fittings
Radiator Black Ice Xtreme Blue II
10 Feet Tygon Tubing
Bay Rez Dual Floppy 3.5 Bay Reservoir
Maze 4 GPU
Swiftech MCP-600 12volt Pump Rev.II
Here is a link of my case and all of it's air components atm.
http://www.ocforums.com/showthread.php?s=&threadid=274848
Was thinking of moving the bottom harddrive next to the top one in pic. Should leave enough room for Dual Floppy 3.5 bay reservoir. Modded my case with 80mm blowhole with window. Was thinking of modding a new window on top of case with 2 120mm holes. Was going to move my cd rom and cd-rw drive on two bottom 5 1/4 bays. Is there any way I can mount the Black Ice Xtreme II Radiator in the top two 5 1/4 bays having the 2 120mm fans pulling the heat from the radiator out of the newly modded window with the two 120mm blowholes. Problems I am thinking I may encounter is equipping the shroud and fans equipped on radiator and getting enough clearance to run tubing without kinking the tubing. Any suggestions if this will work or better ideas to set up this watercooling system with my current case?