• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

help water is gone too quick

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

vietp13

Member
Joined
Mar 20, 2003
like about an 1 hour pass 1inch of water is gone from my t-line i check theres no leak or anything any tips of how to stop this fast? :confused:
 
well unless the water is evaporating out of your t-line, then the water has to be leaking somwhere. And your t-line should have a cap on it to eliminate evaporation...
 
I bet he's still bleeding his lines. The water is going down because there are small bubbles still in your lines, rad, pump that take time to get out. So your water level will slowly go down until all of the air is out of the loop.
 
sigh.. bleeding takes too long been bleeding it since last night and i installed the set up this afternoon back in
 
Back