- Joined
- May 20, 2004
I just got all my componants in the mail. two of the things I got were the MCW50 graphics block and 2 1/2" barb converters to fit into the quick connect slots to allow for 1/2"ID tubing instead of the 3/8" the quick connects offer.
I unpacked the block and in my haste and excitement, I just stuck the two barbs into the block. they fit perfectly, and I made sure they were nice and tight on there, but the actual plastic piece they fit into, seems to wiggle a little bit. I tried taking them out but they're WAY to snug in there, and I can't push them any deeper either.
Here is a picture of the block with the barbs and the quick connects right next to it.
I unpacked the block and in my haste and excitement, I just stuck the two barbs into the block. they fit perfectly, and I made sure they were nice and tight on there, but the actual plastic piece they fit into, seems to wiggle a little bit. I tried taking them out but they're WAY to snug in there, and I can't push them any deeper either.
Here is a picture of the block with the barbs and the quick connects right next to it.