- Joined
- Oct 15, 2003
- Location
- Missouri
well would it... because the danner mag 7 is what i plan to git for my ultimate WC system when i git the money lol...thx for the replies guyz
-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
Would the MCP600 Beat the Danner Mag 7???
- Thread starter Sophisticated
- Start date
- Joined
- Jul 13, 2003
- Location
- San Jose, CA
Hmmm, 10 watts compared to 60 watts of power. So how much heat do you want to add to the water?
I'd rather use two MCP600s.
I'd rather use two MCP600s.
- Joined
- Nov 30, 2002
- Location
- California
mag 7 has higher head as well as higher flow.
unless u plan on running a lot of tubing, it would probably be better to get a mag 3 instead. has the same head as a mcp600 and double the flow.
unless u plan on running a lot of tubing, it would probably be better to get a mag 3 instead. has the same head as a mcp600 and double the flow.
- Joined
- May 6, 2003
- Location
- Buried in UPS packages
In terms of watercooling a pc then the mcp600 would do much better. The amount of heat the Mag7 would put into the system would defeat any extra cooling the high flow would do. Now comared to the Mag3 the MCP600 would perform a little less. I tried both in the same setup and the Mag3 came out on top in terms of flow and cooling.
- Joined
- May 11, 2004
- Location
- West Coast
Where can I find a mag 3? And is that the entire name of the pump of an abbreviation?
- Joined
- Nov 30, 2003
- Location
- Illinois
its the danner mag 3. thats the full name
Similar threads
