So I decided to switch from a chevette core to caprice core. I was going to get 2 dtek heater core shrouds to use on the caprice core, but then i figure I would try to make one myself. I tried cardboard first didnt like it, ugly and funny fit. So I went to home depot and bought a sheet of plexi glass. Did some measurements, busted out the trusty ol dremel and went to town. If you do this make sure you are in a well ventelated area, funny smell when cutting plexi. I must admit it is hard to cut in a straight line but i managed. Used two cds for cutouts where the fans would go. gooped it up with silicone( i think i went overboard, but i wanted to make sure no air leakage) and whoola a fan shroud. Its not the prettiest thing in teh world but im damn proud of my own creation. If i had somewhere to host the pics i would post them. For those of you who were in my shoes and a little hesitant about modding and fabricating stuff, buy a dremel and make the plunge. Its fun as heck and a lot cheaper also. Now time for that beer
Last edited: