Anyone have a picture of a properly installed A64 TDX?

I'm confused. It didn't come with an installation manual, and I have never installed a heatsink or waterblock on an A64 system. I don't know if I should use the backplate AND the the plate that goes on the front (the "frontplate?"), or just the backplate, and where each nylon washer goes.. so confused!

Thanks!

reading/research is your friend

http://www.dangerden.com/Instructions/TDX_Guide.pdf"

Yes, it is, I have read that already and that is not Athlon 64 specific instructions.

Dont use the backplate. The waterblock installs like any other heatsink/waterblock, it bolts directly onto the motherboard.

If you have specific questions on Danger Den products, I recommend emailing tech support.

[email protected]