- Joined
- Jul 15, 2004
- Location
- Loma Linda, CA
Hey all, after a few remounts of my WW block, I found out that the tubing is pulling a bit on it, so I actually had to tighten one side a a bit more to get even contact.
I am now getting a load temp w/ Prime95 of 38C... we'll see what happens when I get the video card nice and hot with it, shouldnt add more than 3C id guess?
Anyway, right now I'm running Barton 2500+ 2.2ghz @1.84 volts.... prolly dont need that many volts, i'll play with it, and see if it can go higher or not. Those Mobile XP chips are VERY tempting too....
Watercooling specs:
D-Tek White Water ALU-topped CPU Block
Swiftech MCW50 GPU Block
Cylinder Res
Danner Mag 3 Pump
'86 Chevette HC w/ Dual 120x38mm Y.S. Techs push/pull w/ GLADWARE shrouds [courtesty of the guide on this forum!]
So far so good... I'll get some pics later for you all.
I am now getting a load temp w/ Prime95 of 38C... we'll see what happens when I get the video card nice and hot with it, shouldnt add more than 3C id guess?
Anyway, right now I'm running Barton 2500+ 2.2ghz @1.84 volts.... prolly dont need that many volts, i'll play with it, and see if it can go higher or not. Those Mobile XP chips are VERY tempting too....
Watercooling specs:
D-Tek White Water ALU-topped CPU Block
Swiftech MCW50 GPU Block
Cylinder Res
Danner Mag 3 Pump
'86 Chevette HC w/ Dual 120x38mm Y.S. Techs push/pull w/ GLADWARE shrouds [courtesty of the guide on this forum!]
So far so good... I'll get some pics later for you all.