• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

My Torin Shroud! Pictures included.

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

klath

Member
Joined
Apr 28, 2004
Location
Bay Area, California
Had some left over lexan from my case mods (not done yet) so I decided to make a shroud for my Torin. Notice that the torin points downwards since a LOT more air tends to go upwards from the outlet of the torin than downwards. Anyone who owns a Torin knows what I'm talking about.

The inside is sealed with neoprene so there's no air leakage. There's also some neoprene on the top of the outside as well.

On the other side of the torin is a pulling 120mm evercool at 7V. The Torin shaved 4C off my load temps from 44C to 40C.
 

Attachments

  • DSC00429.JPG
    DSC00429.JPG
    62.3 KB · Views: 254
  • DSC00432.JPG
    DSC00432.JPG
    46.3 KB · Views: 207
  • DSC00439.JPG
    DSC00439.JPG
    62 KB · Views: 198
  • DSC00440.JPG
    DSC00440.JPG
    60.9 KB · Views: 186
  • DSC00445.JPG
    DSC00445.JPG
    54.8 KB · Views: 204
Last edited:
Here's a pic of the front (still need to add bottom flood LEDs) for now.

Also, inside is a filter to prevent pesky dust from clogging up the radiator. It's actually stretched one dollar pantyhose I picked up from Walgreens.

Also, here's a small movie of the reservoir in action. I left a little in there to get the flowing effect and a nice soothing water noise. Don't worry, there's no air going into the outlet of the reservoir either. Who says you have to top off a bay res. ;)

Edit: Apparently my hosting doesn't like MPG from indirect link so no link. Sorry.
 

Attachments

  • DSC00448.JPG
    DSC00448.JPG
    28.8 KB · Views: 187
  • DSC00425.JPG
    DSC00425.JPG
    46 KB · Views: 171
Last edited:
Back